wl: module license 'MIXED/Proprietary' taints kernel. I have also entered etc/modprobe.d/nf and commented out the section bcm43XX sudo apt-get install -reinstall bcmwl-kernel-source Namely I have made sure the appropriate modules are installed. I have followed the the top answer at this link. Memory at b0400000 (64-bit, non-prefetchable) Memory at b0600000 (64-bit, non-prefetchable) BCM4360 802.11ac Wireless Network Adapterįlags: bus master, fast devsel, latency 0, IRQ 18 and subsidiaries BCM4360 802.11ac Wireless Network Adapter (rev 03) Network Controller Info:Ġ3:00.0 Network controller: Broadcom Inc. This is due to problems surrounding my network controller. At the same time, I was able to successfully connect to the created WPA3 wireless network using my Android phone so the network itself seems to be configured correctly.ĭoes anyone have a similar experience with WPA3 not working on BCM4360 WiFi adapter? If yes, is it an issue with the hardware, the kernel module driver or perhaps something else? And can it potentially be fixed, e.g.Hello I am using Ubuntu 18.04 and am unable to connect to the wifi. The BCM4360 WiFi adapter was still unable to connect and the error messages reported by wpa_supplicant were the same. I have also tried configuring the WiFi network to use the WPA2-PSK/WPA3-SAE mixed mode for authentication but it did not have any observable effect. Perhaps the error messages from wpa_supplicant indeed mean that the encountered WPA3-specific suite selectors are not supported by some part of the used WiFi stack but I am not sure how to verify that. A STA shall allow at least AKM suite selector 00-0F-AC:8 to be selected for an associationĪ STA shall not allow AKM suite selector: 00-0F-AC:2, 00-0F-AC:6 to be selected for an association
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |